OXVA NeXLIM Go

Both mesh coils fire at the same time. This doubles the active heating surface, producing richer flavour, more vapour, and a warmer draw. Best paired with an open airflow setting for restricted direct-lung vaping. Uses more battery and reduces pod life compared to ECO mode.

Each coil fires independently, alternating with every puff. This cuts the workload per coil in half, extending pod life to 20-30 refills and significantly improving battery efficiency. Flavour remains strong thanks to the full mesh surface on each individual coil. Best for mouth-to-lung draws with a tighter airflow setting.

Remove the NeXLIM Go from the packaging. The 0.8Ω NeXLIM cartridge comes pre-installed. Remove any protective caps or stickers from the pod and mouthpiece before first use.

Open the rubber stopper on the top of the cartridge to access the fill port. Add your preferred nicotine salt or freebase e-liquid. A 50/50 VG/PG ratio works well with the 0.8Ω cartridge. Close the stopper securely and let the pod sit for 3-5 minutes so the dual mesh wicks can fully saturate before your first draw.

Locate the slide switch on the side of the device (opposite the airflow slider). Slide it down for ECO mode (single coil, longer battery and pod life) or up toward the flame icon for BOOST mode (dual coil, maximum flavour). Start with ECO mode if you are new to the device.

The airflow slider is on the opposite side from the mode switch. Slide it toward closed for a tight mouth-to-lung draw or toward open for a looser restricted direct-lung pull. In ECO mode, a tighter setting works best. In BOOST mode, try a more open setting for warmer, fuller vapour.

The NeXLIM Go is draw-activated. Inhale from the mouthpiece to fire the device. The OXVA logo at the base will light up in green (65-100%), blue (30-65%), or red (below 30%) to indicate your remaining battery level.

When the LED indicator turns red, connect any USB Type-C cable to the charging port (located below the mode switch). A full charge takes approximately 45 minutes. Replace the cartridge when you notice reduced flavour or vapour output, typically after 20-30 refills in ECO mode or 10-15 refills in BOOST mode.

The NeXLIM Go works with both nicotine salt and freebase e-liquids. For the included 0.8Ω cartridge, nicotine salt at 20mg/mL in a 50/50 VG/PG ratio delivers excellent flavour and throat hit in both ECO and BOOST modes. If you prefer freebase, a 3-12mg strength in 50/50 or 60/40 VG/PG works well. The 0.6Ω cartridge is better suited to freebase at higher VG ratios since it runs at higher wattage. Browse our nicotine salt e-liquids and freebase e-liquids to find the right pairing.

No. The NeXLIM Go uses NeXLIM-series cartridges exclusively. These pods are physically different from XLIM V2, V3, and EZ pods and are not cross-compatible. If you are already invested in the XLIM pod ecosystem, the OXVA XLIM GO 2 may be a better fit since it works with all existing XLIM pods.

ECO mode fires one mesh coil at a time, alternating between the two coils with each puff. This extends battery life significantly and can push pod longevity to 20-30 refills. BOOST mode fires both mesh coils simultaneously, which roughly doubles the heating surface and produces noticeably richer flavour and more vapour. The trade-off is that BOOST mode uses more battery (roughly half the runtime of ECO mode) and reduces pod life. A physical slide switch on the side of the device lets you toggle between modes instantly.

Battery life depends heavily on which mode you use and how often you vape. OXVA rates the 1800mAh battery for up to 10 days in ECO mode with light use. For regular daily vapers, ECO mode typically provides 3-5 days between charges. BOOST mode cuts that roughly in half. The tri-colour LED built into the OXVA logo shows green above 65%, blue between 30-65%, and red below 30%, so you always know where you stand.

Yes. The NeXLIM Go is entirely draw-activated with no buttons, screens, or menus. The device auto-adjusts wattage to your pod, and the only two physical controls are the ECO/BOOST switch and the airflow slider. If you are switching from disposable vapes or cigarettes, start with the included 0.8Ω cartridge in ECO mode with a tight airflow setting and a 20mg nicotine salt e-liquid. This combination provides a familiar cigarette-like draw with strong nicotine satisfaction. See our full pod vape systems collection to compare options.

OXVA rates the NeXLIM cartridges for 20-30 refills in ECO mode before noticeable flavour degradation. In BOOST mode, expect roughly 10-15 refills since both coils are working simultaneously on every puff. With the 2mL CRC pod capacity, that translates to approximately 40-60mL of e-liquid per cartridge in ECO mode. Sweeter e-liquids will reduce coil life, while cleaner profiles like menthol and tobacco tend to extend it.

The NeXLIM Go is a refillable device, which means significantly lower cost per use compared to disposables. A single NeXLIM cartridge that lasts 20-30 refills combined with a 30mL bottle of e-liquid will outlast dozens of disposable vapes. You also get to choose your own flavours, nicotine strength, and VG/PG ratio. The dual mesh coils in the NeXLIM Go deliver flavour quality that consistently outperforms most disposable devices according to reviewer testing. The trade-off is that you fill the cartridge yourself, which takes about 10 seconds. If you are not ready to switch, browse our disposable vapes collection.